low sulphur fuel – Officer of the Watch

Transport Canada Fuel Oil Sulphur Content Inspections

Effective August 22, 2016, Transport Canada Marine Safety Inspectors will verify compliance with the 0.10% sulphur content requirements for fuel oil used on board ships operating within the Canadian jurisdiction of the North American Emission Control Area through on-site fuel sampling and testing.

Since January 1, 2015, the sulphur content of marine fuel used on board a vessel must not exceed 0.10% by mass within the Canadian jurisdiction of the NA-ECA, as set out in Section 111 of the Regulations. The NA-ECA standard should provide important benefits to Canada. It is expected to result in a more than 90% decline in sulphur oxide emissions from vessels.

Since most vessels must use more expensive low sulphur fuel oil to comply with these standards compared to vessels operating outside of ECAs under MARPOL, Transport Canada will rigorously monitor vessels to ensure they are complying with the NA-ECA standards.

Transport Canada will use portable fuel analyzers onboard vessels to measure the sulphur content of its fuel oil to verify compliance with the NA-ECA standard. Test results will help inspectors make informed decisions on the next enforcement steps during the course of the inspection.

During an inspection of a vessel, a Marine Safety Inspector may require a sample of fuel from the engine’s fuel system and perform an analysis of the fuel sample using a fuel analyzer.

Depending on the results of the analysis, the inspector may also forward the samples to an accredited laboratory to confirm compliance with the fuel oil sulphur content requirements. If the analyzer is not available, the inspector may forward the fuel sample directly to the laboratory for analysis.

The vessel’s authorized representative will be informed of the analytical results. In addition, Transport Canada will share the results with industry stakeholders, other maritime administrations and the International Maritime Organization, but will make data on individual ships anonymous.

The Ship Safety Bulletin No. 08/2016, is available at: http://www.tc.gc.ca/eng/marinesafety/bulletins-2016-08-eng.htm

Best Practices in Recent Loss Prevention Incidents

The following presentation/article makes a brief review of best practices in loss prevention that have been collected from some of the recent UK P&I Club loss prevention bulletins, hence a UK P&I Club miscellany.

[Read more…]

Engine Worn Out by Catalytic Fines

DNV has over the last years seen an increase in engine damage due to catalytic fines, even though the bunkered fuel has been in accordance with ISO 8217 marine fuel specification and fuel treatment is standard procedure and implemented for all vessels. Damage (incident occurred in 2010), that can be traced back to catalytic fines occurred after only 100 running hours, making the engine totally inoperable. All pistons and liners were totally destroyed and had to be changed.